Pyramix 6.2 SP2 Instrukcja Obsługi Pobierz pdf (Strona 14)

System Information

To install IRIX 6.5.28, you require the following SGI CDs:

• IRIX 6.5.28 Installation Tools and Overlays (1 of 3) August 2005—P/N 812-0818-028

• IRIX 6.5.28 Overlays (2 of 3) August 2005—P/N 812-0819-028

• IRIX 6.5.28 Overlays (3 of 3) August 2005—P/N 812-0817-028

• IRIX 6.5 Applications August 2005—P/N 812-0877-028

• IRIX 6.5 Foundation 1—P/N 812-0759-002

• IRIX 6.5 Foundation 2—P/N 812-0760-002

• ONC3/NFS version 3, for IRIX 6.2, 6.3, 6.4, and 6.5—P/N 812-0774-002

Make sure that your CDs match this list precisely. If you do not have the correct CDs, contact

your SGI support representative.

For IRIX upgrade and full installation procedures, see the IRIX 6.5.28 Installation Guide.

DKU Version Requirement

The 2007 SP4 release of your Effects or Editing application requires the DKU version 2.1.3. If

you are upgrading from 2007 SP3, this DKU should already be installed. Otherwise you must

perform a DKU upgrade. For more information about installing the customized kernel on your

workstations, see “Installing the Discreet Kernel Utility” in the Autodesk Effects and Editing

2007 Linux RHEW 4(Update2 or Update 3) Installation and Configuration Guide.

Hardware System Requirements

Linux workstations —

This release fully supports all previously certified Linux workstations.

However, some minor changes in video I/O connections or BIOS revision may be required if

you are upgrading from a pre-2007 version of your Effect or Editing application. Consult these

Release Notes and the Hardware Setup Guide for your workstation for information on BIOS

requirements, connection to audio/video I/O hardware and other peripherals.

SGI workstations —

This release fully supports the Octane2™ V12, Tezro™, Onyx2® (R12K),

Onyx 350, and Onyx 3200 workstations. No changes in hardware configuration are required.

For specifications, you can consult your existing documentation or download the Hardware

Setup Guide for your workstation at www.autodesk.com/discreet-documentation.

New XR-series Stone Direct —

The new XR-series Autodesk Stone® Direct storage is now

available in 4Gb mode for all Linux workstations (4Gb fibre channel adapters required). XR-

series is also supported in 2Gb mode on SGI workstations. Consult the Stone Direct 2007

Configuration Guide and the Stone Storage Manager 2007 for information on how to connect

and configure your XR-series Stone Direct.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Brak uwag

Pyramix 6.2 SP2 Instrukcja Obsługi Strona 14