Pyramix 6.2 SP2 Instrukcja Obsługi Pobierz pdf (Strona 17)

Enabling InfiniBand Drivers on Linux Workstations

InfiniBand (IB) drivers are now certified for IBM 6217SC/DC, HP xw8400 and HP xw9400

workstations. The drivers are installed on all Linux workstations by the DKU. If the DKU

detects the IB hardware, the chkconfig flag for IB drivers is set to ON. If you add an optional IB

HBA after the DKU was initially installed, the chkconfig flag for the IB drivers will not be

properly set.

The following procedures describe how to use the InfiniBand configuration utility to set the

chkconfig flag to ON for the IB drivers and configure the IP address and netmask of your

Infiniband interface.

To enable the chkconfig flag for IB drivers on a Linux workstation:

1. Open a shell and log in as root.

2. Start the InfiniBand configuration utility. Type:

/sbin/iba_config

The InfiniBand configuration utility menu appears:

SilverStorm Technologies Inc. InfiniBand 3.2.0.2.1G Software

1) Show Installed Software

2) Reconfigure IP over IB

3) Reconfigure Driver Autostart

4) Update HCA Firmware

5) Generate Supporting Information for Problem Report

6) Host Setup via Fast Fabric

7) Host Admin via Fast Fabric

8) Chassis Admin via Fast Fabric

9) Uninstall Software

X) Exit

3. Open the Reconfigure Driver Autostart menu. Type:

4. When you have completed the configuration, exit the InfiniBand configuration utility. Type:

5. You must restart your workstation for your changes to take effect.

After rebooting, launch the InfiniBand configuration utility again to configure IP over IB.

To configure the IP address and netmask of your IB Interface:

1. Open the Reconfigure IP over IB menu. Type:

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Brak uwag

Pyramix 6.2 SP2 Instrukcja Obsługi Strona 17